Unmanned aerial vehicles (UAV) are increasingly used for topographic mapping. The camera calibration for UAV image blocks can be performed <i>a priori</i> or during the bundle block adjustment (self-calibration). For an area of interest with flat, corridor configuration, the focal length of camera is highly correlated with the height of camera. Furthermore, systematic errors of camera calibration accumulate on the longer dimension and cause deformation. Therefore, special precautions must be taken when estimating camera calibration parameters. In this paper, a simulated, error-free aerial image block is generated. error is then added on camera calibration and given as initial solution to bundle block adjustment. Depending on the nature of the error and the investigation purpose, camera calibration parameters are either fixed or re-estimated during the bundle block adjustment. The objective is to investigate how certain errors in the camera calibration impact the accuracy of 3D measurement without the influence of other errors. All experiments are carried out with <i>Fraser</i> camera calibration model being employed. When adopting a proper flight configuration, an error on focal length for the initial camera calibration can be corrected almost entirely during bundle block adjustment. For the case where an erroneous focal length is given for pre-calibration and not re-estimated, the presence of oblique images limits the drift on camera height hence gives better camera pose estimation. Other than that, the error on focal length when neglecting its variation during the acquisition (e.g., due to camera temperature increase) is also investigated; a bowl effect is observed when one focal length is given in camera pre-calibration to the whole image block. At last, a local error is added in image space to simulate camera flaws; this type of error is more difficult to be corrected with the <i>Fraser</i> camera model and the accuracy of 3D measurement degrades substantially.